PRE-INSPECTION REPORTPP-2026-0042Generated 25 Oct 2026, 15:12 IST
COMPONENT QUALITY ASSESSMENT
SIMULATEDTurbine Impeller v2
Stainless steel · SS 316L · IMP-SS316-042
PROTOTYPE DATA
OVERALL VERDICT · PART RELEASE ON HOLDESCALATE TO ZEISS CMM
FLAGGEDCritical dimensional deviation detected. Certified metrology review required.
01
Geometry & deviation evidence
Illustrative mesh comparisonPreparing digital twin
CAD-ALIGNED DEVIATION MAP · mmSpatial coverage94.2%
Target ≥ 90% · Passed
Calibration error±0.035 mm
Simulated uncertainty
Maximum deviation+0.38 mm
7.6× design tolerance
−0.05 mm+0.38 mmGreen = nominal · Red = out of tolerance
02
Detected anomalies
| Finding | Measured / confidence | Acceptance limit | Status |
|---|---|---|---|
| 01 · Flange radius deviationOuter flange critical zone | +0.38 mm | ±0.05 mm | FAIL |
| 02 · Surface micro-scratchNear Datum B | 91% confidence | Visual review | REVIEW |
03
Capture verification checklist
ChArUco board detectedGrid calibration OK · DICT_4X4_50PASS
Motion blur index0.04 · threshold < 0.10PASS
Specular glare / reflectionMinimal · surface features visiblePASS
Orbit angular coverage310° / 360° · threshold > 300°PASS
Recommended next step
Hold this component for formal dimensional inspection. Verify the outer flange radius using a certified CMM and visually review the surface at Datum B before release.
All measurements, model outputs and confidence values in this hackathon prototype are simulated. This report is a pre-inspection demonstration and is not a calibration certificate, validated measurement or product release authorization.